Cart 
- Shop by :
-
Category
- Ankle Braces
- Back Braces
- Cervical Collars
- Chest/Abdominal Braces
- Elbow Braces
- Hand and Wrist Braces
- Knee Braces / Supports
- Lifting Belt
- Shin / Calf Braces
- Shoulder Braces / Supports
- Socks
- Splints
- Support Belt
- Thigh and Hamstring Braces
- Thumb Supports
- Toe Braces and supports
- Walking Braces
- Bathroom Aids
- Bedroom Aids
- Beds
Back Rest and Cushions
Braces and supports
Daily Living Aids
- Lifts
- mattresses
- mattress pads
- Mobility Aids
- Recliners
- Slings
- Trapezes
- ergonomic chairs
- Ankle Weights
- Balance Boards & Training Equipment
- Cycles/Pedlars
- Exercise Equipment
- Exercise Balls
- Exercise Bands
- Exercise Bikes
- Exercise Mats
- Hand Exercisers
- Lifting Gloves
- Lifting Straps
- Recumbent Exercise Bikes
Electrotherapy
Ergonomic Products
Exercise & Fitness
- Strength & Resistance Training
- Training Gloves
- Weight Bars
- Yoga Products
- Cold Therapy
- Heat Therapy
- Professional Massagers
- Massagers
- Massage Chairs
- Portable Massager
- Foot Massagers
- HandHeld Massagers
- Back Massagers
- Massage Oils
- Ankle Magnets
- Magnetic Back Braces
- Magnetic Calf Support
- Magnetic Elbow Braces
- Magnetic Elbow Support
Hot/Cold Therapy
Inversion Table
Massage Products
Magnetic Therapy
- Magnetic Knee Braces
- Magnetic Knee Support
- Magnetic Mattress Pads and Pillows
- Canes
- Walking Canes
- Crutches
- Rollators
- Walkers
- Wheelchairs
- Wheelchairs Accessories
- Wheelchair Cushions
- Knee Walkers
- Posterior Posture Walkers
- Bariatric walkers
- Cushions & Wedges
- Memory Foam Pillow
- water & Air pillows
- Travel Pillows
- Neck Pillows
- Support Cushions
Mobility Aids
Moisture Protection
Pillows
- Positioning Pillows
- Support Pillow
- Snoring Pillows
- Applicators
- Bandage Retainers
- Bandages
- Dressing Trays and Kits
- Dressings
- Gauze Pads
- Ointments & Solutions
- Ostomy Supplies
- Penrose Drain
- Sponges & Strips
- Swabsticks
- Tape
- Tracheostomy
- Wound Closures & Ropes
- Wound Drainage
- Preps and Swabs
Traction Systems
Wound Care
-
Body Area
- Ankle Braces
- Ankle Hot/Cold Wraps
- Ankle Infrared Heat
- Ankle Magnetic Braces
- Walker
Ankle Pain products
- Back Belts
- Back Braces and Back Supports
- Back Massagers
- Car Seat Back Support
- Hot and Cold for the Back
Back Pain Products
- Inversion tables
- Magnetic Pads
- Seat Cushions and Support
- Seat and Bed Wedges and Rolls
Chest/Abdominal Pain Products
Clavicle Pain Products
- Prevention
- Rehabilitation
- Sports
- Bedding Comfort
You're currently on:
When a person stands from the typical recliner, it tilts forward, dropping the arms and seat of an already low chair by 3-4 inches. Simply raising the chair 5 or 6 inches, necessary for independent standing, makes it dangerously unstable. Stander has developed a safe and easy solution! When Recliner Risers are installed, they raise a chair 1 ¾ inches and limit the forward tilt allowing an additional 3-4 inches of lift. The 4-6 total inches of extra support gives a weakened person a biomechanical advantage and enables them to stand on their own. Recliner Risers attach quickly and easily to the wooden base of your favorite recliner. Our patented design raises your effective seat height 4-6 inches while only raising your chair 1 ¾ inches. Each box contains four Recliner Risers, two Rocker Limiters, 16 screws, Velcro, and instruction manual.
| Weight: | 0.9000 |
| Dimensions: | 3" H × 5" W × 12" L |
| Packing Information: | |
| Pack Type | Box |
| Total Quantity | 4 |
| Materials: | |
| Sterile | No |
| Latex | No |
Assembly Steps:
1. Turn the chair on its left side: the leg extension handle will be visible (fig. 2). Using a flathead screwdriver, pry the plastic floor protectors from each corner of the chair base. Install Chair Lifts to the chair base with the provided screws. Make sure Recliner Riser (A) is in front and Recliner Riser (B) is in back. Also, make sure Recliner Risers are snug to chair when the screws are installed. This will ensure a proper fit.
2. Clean any dust from chair base where fastener piece (C) will be attached (fig.3). Remove adhesive backing and apply up to top edge of base. Holding the tab of the left Rocker Limiter, place on fastener piece (C) – the screw will install later. Note: Moving the Rocker Limiter along the 2” inch strip closer or away from the spring complex determines where the chair will stop when one stands up. Adjust to users comfort. Once the preferred setting is found, place a screw through the hole as shown.
3. Turn the chair over onto its right side. Repeat steps in figure 2 and figure 3 for the other side of the chair. Make sure that the Recliner Riser (B) is in front this time and Recliner Riser (A) is in the back.
4. When finished, return the chair to the upright position.
5. NOTE FOR SWIVEL BASED CHAIRS: Base must be switched to a regular base prior to installation. Most chair manufacturers will do this for a small fee.
1. Turn the chair on its left side: the leg extension handle will be visible (fig. 2). Using a flathead screwdriver, pry the plastic floor protectors from each corner of the chair base. Install Chair Lifts to the chair base with the provided screws. Make sure Recliner Riser (A) is in front and Recliner Riser (B) is in back. Also, make sure Recliner Risers are snug to chair when the screws are installed. This will ensure a proper fit.
2. Clean any dust from chair base where fastener piece (C) will be attached (fig.3). Remove adhesive backing and apply up to top edge of base. Holding the tab of the left Rocker Limiter, place on fastener piece (C) – the screw will install later. Note: Moving the Rocker Limiter along the 2” inch strip closer or away from the spring complex determines where the chair will stop when one stands up. Adjust to users comfort. Once the preferred setting is found, place a screw through the hole as shown.
3. Turn the chair over onto its right side. Repeat steps in figure 2 and figure 3 for the other side of the chair. Make sure that the Recliner Riser (B) is in front this time and Recliner Riser (A) is in the back.
4. When finished, return the chair to the upright position.
5. NOTE FOR SWIVEL BASED CHAIRS: Base must be switched to a regular base prior to installation. Most chair manufacturers will do this for a small fee.
